Precautions - Sony 3-287-077-14(2) Operating Instructions Manual

DEVICE FULL: The memory of the USB
device is full.
FATAL ERROR: The USB device was
removed during transferring or erase
operation, and may have been damaged.
FOLDER FULL: You cannot transfer
onto the USB device because the
number of folders have reached its
maximum.
NO STEP: All of the programmed steps
have been erased.
NO TRACK: No playable file is loaded
in the system.
NOT IN USE: You tried to perform a
specific operation under conditions
where that operation is prohibited.
NOT SUPPORTED: An unsupported
USB device is connected, or the USB
device is connected to this system
through a hub.
OVER CURRENT: An over current was
detected.
PROTECTED: The USB device is write-
protected.
PUSH STOP: You tried to perform an
operation that can be performed only
when the system is stopped.
REC ERROR: Transferring did not start,
stopped partway, or otherwise could not
be performed (page 34).
REMOVED: The USB device has been
removed.
STEP FULL: You tried to program more
than 25 steps.
TRACK FULL: You cannot transfer onto
the USB device because the number of
files have reached its maximum.
USB READING: The system is reading
information of the USB device. Some
buttons are not available.
38 GB

Precautions

Discs that this system CAN play
• AUDIO CD
• CD-R/CD-RW (audio data/MP3 files)
Discs that this system CANNOT play
• CD-ROM
• CD-R/CD-RW other than those recorded in
AUDIO CD format or MP3 format
conforming to ISO 9660 Level 1/Level 2,
Joliet in the expansion format
• CD-R/CD-RW recorded in multisession that
have not ended by "closing the session"
• CD-R/CD-RW of poor recording quality,
CD-R/CD-RW that have scratches or are
dirty, or CD-R/CD-RW recorded with an
incompatible recording device
• CD-R/CD-RW which is finalized incorrectly
• Discs containing files other than MPEG 1
Audio Layer-3 (MP3) files
• Discs of non-standard shape (for example,
heart, square, star)
• Discs that have adhesive tape, paper, or
sticker attached to them
• Rental or used discs with attached seals where
the glue extends beyond the seal
• Discs that have labels printed using ink that
feels tacky when touched
Notes on discs
• Before playing, wipe the disc with a cleaning
cloth from the center out to the edge.
• Do not clean discs with solvents, such as
benzine thinner, or commercially available
cleaners or anti-static spray intended for vinyl
LPs.
• Do not expose discs to direct sunlight or heat
sources such as hot air ducts, nor leave it in a
car parked in direct sunlight.