Sony STR-DN1010 Operating Instructions Manual page 79

To perform pairing
1
Place the S-AIR sub unit that
you want to pair near the S-AIR
main unit.
2
Match the IDs of the S-AIR main
unit and the S-AIR sub unit.
• To set the ID of the S-AIR main unit,
see "To set the ID of the S-AIR main
unit" (page 77).
• To set the ID of the S-AIR sub unit,
refer to the operating instructions
supplied with the S-AIR sub unit.
3
Press GUI MODE.
After "MENU ON" appears on the
display for a while, "GUI" appears and
the GUI menu appears on the TV screen.
Press MENU if the GUI menu does not
appear on the TV screen.
4
Press V/v repeatedly to select
"Settings", then press
The Settings menu list appears on the TV
screen.
5
Press V/v repeatedly to select
"S-AIR", then press
Note
When the S-AIR transmitter (not supplied) is
not inserted into the S-AIR main unit, "S-AIR"
cannot be selected.
6
Press V/v repeatedly to select
"Pairing", then press
"Put the S-AIR sub unit near the S-AIR
main unit. Turn on power and start
pairing." appears on the TV screen. The
S-AIR main unit is ready to start pairing.
7
Press B/b repeatedly to select
"Yes", then press
The S-AIR main unit starts pairing.
"Pairing. Do the pairing operation with
the S-AIR sub unit." appears.
8
9
or b.
10
or b.
If pairing fails
"Pairing failed. Retry?" appears.
or b.
To perform pairing again, select "Yes".
To finish pairing, select "No".
To quit pairing during setting
Press RETURN/EXIT O.
.
To cancel pairing
Perform the ID setting of the main unit
according to the procedure of "To set the ID of
the S-AIR main unit" (page 77). If you reset
the ID (even the same ID again), pairing is
canceled.
Start pairing of the S-AIR sub
unit.
Refer to the operating instructions of the
S-AIR sub unit.
Notes
• Perform pairing within 5 minutes in step 7. If
you do not, pairing is recognized as failed,
and the screen changes accordingly. In this
case, see "If pairing fails" (page 79).
• When sound transmission is established,
"Pairing complete. To do the pairing another
one, select "Continue"." appears.
Press B/b repeatedly to select
"Finish" or "Continue", then
press .
• "Finish": Finishes pairing.
• "Continue": Continues to perform
pairing to another S-AIR sub unit.
Tip
You can confirm the pairing completion or the
current ID by checking the "S-AIR Settings"
screen. "Pairing" appears beside the current
S-AIR ID.
Press GUI MODE.
The GUI menu turns off.
Note
After you have performed pairing, if you select
the "S-AIR ID" menu, the ID setting ("A", "B"
or "C") that you last used is displayed.
GB
79