Using the Remote
Changing button
assignments
You can change the factory settings of the
input buttons to suit the components in your
system. For example, if you connect a DVD
recorder to the VIDEO 1 jacks on the receiver,
you can set the VIDEO 1 button on this remote
to control the DVD recorder.
1
Hold down the input button of
which you want to change the
assignment.
Example: Hold down VIDEO 1.
2
Referring to the table below,
press the corresponding button
for the category you want.
Example: Press 4.
Now you can use the VIDEO 1 button to
control the DVD recorder.
40
GB
Categories and the
corresponding buttons
Categories
VCR (command mode VTR 3)
VCR (command mode VTR 2)
DVD player/DVD recorder
(command mode DVD1)
DVD recorder
(command mode DVD3)
CD player
MD deck
Tape deck B
Tuner (this receiver)
DVR (Digital CATV terminal)
DSS (Digital Satellite Receiver)
a)
Sony VCRs are operated with a VTR 2 or VTR 3
setting which correspond to 8 mm and VHS
respectively.
b)
Sony DVD recorders are operated with a DVD1 or
DVD3 setting. For details, refer to the operating
instructions supplied with the DVD recorders.
To clear all remote button
assignments
Press ?/1, TEST TONE and MASTER VOL –
at the same time.
The remote is reset to its factory settings.
Press
a)
1
a)
2
3
b)
4
b)
5
6
7
8
9
0/10