Adjusting The Tone - Sony STR-DG300 Operating Instructions Manual

x A.V. SYNC. (A/V Sync)
• A.V.SYNC. Y (Yes) (Delay time: 68 ms)
The audio output is delayed so that the time
gap between the audio output and visual
display is minimized.
• A.V.SYNC. N (No) (Delay time: 0 ms)
The audio output is not delayed.
Notes
• This parameter is useful when you use a large LCD
or plasma monitor or a projector.
• This parameter is valid only when you use a sound
field selected with the A.F.D. button.
• This parameter is not valid when
– PCM 96 kHz or DTS 2048 signals are input.
– ANALOG DIRECT function is selected.
x SW PHASE (Sub woofer phase
polarity)
Lets you set the sub woofer phase polarity.
• NORMAL
Normally, select "NORMAL".
• REVERSE
Depending on the type of front speakers, the
position of the sub woofer, and the cut-off
frequency of the sub woofer, setting the
phase polarity to "REVERSE" may produce
better bass. Besides bass reproduction, the
richness and tightness of the overall sound
may also be affected. While listening from
the main listening position, select the setting
that best suits your environment.
x DIMMER (Brightness of the
display)
Lets you adjust the brightness in 3 steps.
28
GB

Adjusting the tone

You can adjust the tonal quality of the front
speakers using the TREBLE +/– and BASS
+/– buttons on the receiver.
Press TREBLE +/– repeatedly to
adjust the treble level and press
BASS +/– repeatedly to adjust the
bass level.
Initial setting: 0 dB
You can adjust from –6 dB to +6 dB in 1 dB
step.