Fujitsu LifeBook S Series Manual page 84

L i f e B o o k S S e r i e s - S e c t i o n 5
*Keyboard controller error
The keyboard controller test failed. You may have
to replace your keyboard or keyboard controller
but may be able to use an external keyboard until
then. Contact your support representative.
*Keyboard error
Keyboard not working. You may have to replace
your keyboard or keyboard controller but may be
able to use an external keyboard until then.
Contact your support representative.
*Keyboard error nn
BIOS discovered a stuck key and displays the
scan code for the stuck key. You may have to
replace your keyboard but may be able to use
an external keyboard until then. Contact your
support representative.
*Monitor type does not match CMOS – Run
SETUP
Monitor type not correctly identified in setup. This
error probably means your BIOS is corrupted,
run the setup utility and set all settings to the
default conditions. If you still get this error, contact
your support representative.
*Operating system not found
Operating system cannot be located on either
drive A: or drive C: Enter the setup utility and
see if both the fixed disk, and drive A: are properly
identified and that the boot sequence is set
correctly. Unless you have changed your
installation greatly, the operating system should
be on drive C:. If the setup utility is correctly set,
your hard drive may be corrupted.
*Parity Check 1 nnnn
Parity error found in the system bus. BIOS
attempts to locate the address and display it on
the screen. If it cannot locate the address, it
displays ????. This is a potentially data-
destroying failure. Contact your suppor t
representative.
72
LB_GARLICS 05 (57-74)
*Parity Check 2 nnnn
Parity error found in the I/O bus. BIOS attempts
to locate the address and display it on the screen.
If it cannot locate the address, it displays ????.
This is a potentially data-destroying failure.
Contact your support representative.
*Press <F1> to resume, <F2> to SETUP
Displayed after any recoverable error message.
Press the [F1] key to continue the boot process
or the [F2] key to enter setup and change any
settings.
*Previous boot incomplete –
Default configuration used
Previous Power On Self Test did not complete
successfully. The Power On Self Test will load
default values and offer to run Setup. If the
previous failure was caused by incorrect values
and they are not corrected, the next boot will likely
fail also. If using the default settings does not
allow you to complete a successful boot
sequence, you should turn off the power and
contact your support representative.
*Real time clock error
Real-time clock fails BIOS test. May require board
repair. Contact your support representative.
*Shadow RAM Failed at offset: nnnn
Shadow RAM failed at offset nnnn of the 64k
block at which the error was detected. You are
risking data corruption if you continue. Contact
your support representative.
nnnn Shadow RAM Passed
Where nnnn is the amount of shadow RAM in
kilobytes successfully tested.
*System battery is dead – Replace and run
SETUP
The BIOS CMOS RAM memory hold up battery
is dead. This is part of your BIOS and is a board
mounted battery which requires a support
representative to change. You can continue
operating but you will have to use setup utility
default values or reconfigure your setup utility
every time you turn off your notebook. This battery
has an expected life of 2 to 3 years.
72 21/7/03, 6:27 PM