Regulatory Information; Notice - Fujitsu LifeBook S Series Manual

L i f e B o o k S S e r i e s - S e c t i o n 7

Regulatory Information

NOTICE

Changes or modifications not expressly approved
by Fujitsu could void this user's authority to
operate the equipment.
FCC NOTICES
Notice to Users of Radios and Television
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses, and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet that is
on a different circuit than the receiver.
• Consult the dealer or an experienced radio/
TV technician for help.
Shielded interconnect cables must be employed
with this equipment to ensure compliance with
the pertinent RF emission limits governing this
device.
Notice to Users of the US Telephone
Network
This equipment (Modem Fujitsu Media Devices
MBH7MD33) complies with Part 68 of the FCC
rules, and the requirements adopted by ACTA.
On the bottom of this equipment is a label that
contains, among other information, the FCC
registration number and ringer equivalence
number (REN) for this equipment; or a product
identifier in the format US:AAAEQ##TXXXX. If
requested, this information or number must be
provided to the telephone company.
90
LB_GARLICS 07 (81-92)
This equipment is designed to be connected to
the telephone network or premises wiring using
a standard jack type USOC RJ11C. A plug and
jack used to connect this equipment to the
premises wiring and telephone network must
comply with the applicable FCC Part 68 rules
and requirements adopted by the ACTA. A
compliant telephone cord and modular plug is
provided with this product. It is designed to be
connected to a compatible modular jack that is
also compliant.
The ringer equivalent number (REN) of this
equipment is 0.0B as shown on the label. The
REN is used to determine the number of devices
that may be connected to a telephone line.
Excessive RENs on a telephone may result in
the devices not ringing in response to an
incoming call. In most but not all areas, the sum
of RENs should not exceed five (5.0). To be
certain of the number of devices that may be
connected to a line, as determined by the total
RENs, contact the local telephone company.
If this equipment causes harm to the telephone
network, the telephone company will notify you
in advance that temporary discontinuance of
service may be required. But if advance notice
isn't practical, the telephone company will notify
the customer as soon as possible. Also, you will
be advised of your right to file a complaint with
the FCC if you believe it is necessary.
The telephone company may make changes in
its facilities, equipment, operations or procedures
that could effect the operation of the equipment.
If this happens the telephone company will
provide advance notice in order for you to make
necessar y
uninterrupted service.
If trouble is experienced with this equipment, for
repair or warranty information, please refer to the
manual or contact Fujitsu, Customer Service. If
the equipment is causing harm to the telephone
network, the telephone company may request
that you disconnect the equipment until the
problem is resolved.
90
modifications to maintain
21/7/03, 6:28 PM