Specifications - Sony TA-VA80ES Operating Instructions Manual

Additional Information

Specifications

Amplifier section
POWER OUTPUT
Stereo mode
(4 ohms at 1 kHz THD 0.7%)
100 W + 100 W
Surround mode (4 ohms at 1 kHz THD 0.7%)
Front: 100 W + 100 W
Center
Rear
1) Depending on the sound field settings and the
source, sound will not be output.
Frequency response
PHONO: RIAA equalization curve
±0.5 dB
CD, TAPE, DAT/MD, TUNER, VIDEO 1, 2:
10 Hz - 50 kHz
Inputs
PHONO
TAPE, DAT/MD, CD,
TUNER, VIDEO 1, 2, 3,
LD, TV
LD AC-3 RF
LD/TV/CD/DAT MD
OPTICAL
LD COAXIAL
2) '78 IHF
Outputs VIDEO 1, 2 AUDIO OUT:
Voltage: 150 mV
Impedance: 10 kilohms
PRE OUT:
Voltage: 2 V
Impedance: 1 kilohms
PHONES:
Accepts low and high impedance headphones
BASS BOOST +6 dB at 70 Hz
EN
26
1) : 100 W
1)
: 100 W + 100 W
+0
dB (with DIRECT PASS on)
–1
S/N (weighting
network, input
Impedance
Sensitivity
level)
2.5 mV 50 kilohms
(A, 2.5 mV)
150 mV 50 kilohms
(A, 150 mV)
— 75
(A, 20 kHz LPF)
— —
(A, 20 kHz LPF)
0.5 Vp-p 75
(A, 20 kHz LPF)
Digital signal processor section
Modulation (A/D conversion)
Demodulation (D/A conversion)
Sampling frequency
Surround
Equalizer
75 dB 2)
82 dB 2)
Video section
Inputs
100 dB
Outputs
100 dB
General
System
100 dB
Power requirements
Power consumption
AC outlets
Dimensions
Mass (Approx.) 15.6 kg
Supplied accessories
Design and specifications are subject to change without
notice.
High Density Linear Converter
High Density Linear Converter (Advanced pulse
D/A converter)
48 kHz
LFE MIX: MUTE, –20 - 0 dB, 0.5 dB step
D. COMP: OFF, 0.1 - 0.9, STD, MAX
REAR level: –20 - +10 dB, 0.5 dB step
CENTER level: –20 - +10 dB, 0.5 dB step
SUB WOOFER level: –20 - +10 dB, 0.5 dB step
EFFECT: 21-step adjustable
WALL: 17-step adjustable
SEAT F/R: 17-step adjustable
SEAT L/R: 17-step adjustable
REVERB time: 17-step adjustable
Depending on the sound field, some parameters
may not be adjustable (see page 21).
BAND: BASS/TREBLE
Turnover frequency:
Bass: 99 Hz - 992 Hz
Treble: 1.0 kHz - 8.6 kHz
Level: ±10 dB, 0.5 dB step
1 Vp-p 75 ohms
1 Vp-p 75 ohms
Preamplifier section:
Low-noise NF type equalizer
Power amplifier section:
Pure-complementary SEPP
230 V AC, 50/60 Hz
380 W
1 switched, maximum
100 W
430 160 435 mm including projecting parts and
controls
See page 4.