Control Locations - Quasar HQ-2243TH,LWC081 Service Manual

1.5 CONTROL LOCATIONS

• OPERATION
Off - Turns air conditioner off.
Med Fan - Med speed fan operation without cooling.
Low Fan - Low speed fan operation without cooling.
High Cool - Cooling with high speed fan operation.
Med Cool - Cooling with med speed fan operation.
Low Cool - Cooling with low speed fan operation.
• THERMOSTAT
This automatically controls the temperature of the indoor air.
Turn the knob so that arrow points to the higher number for
greater cooling. Point the arrow to the lower number for more
moderate cooling.
(i.e. the higher the number, the greater the cooling)
• FOR NORMAL COOLING
1. Turn the operation switch to the High Cool or the Low
Cool setting.
2. Set the Thermostat control to the desired temperature
mark 5 (the mid-point is a good starting position).
If the room temperature is not satisfactory after a
reasonable time, adjust the control to a cooler or warmer
setting, as appropriate.
When the air conditioner has performed its cooling operation and is turned off or set to the fan position, wait at least 3
minutes before resetting to the cooling operation again.
• FOR MAXIMUM COOLING
1. Turn the Operation Knob to the High Cool setting.
2. Set the Thermostat control to the highest (9) temperature
mark.
• FOR QUIETER OPERATION
1. Turn the Operation Knob to the Low Cool setting.
2. Set the Thermostat control as needed.
• AIR SWING
ON - Air swing is operated while OPERATION Knob is
set to the COOL position.
OFF - Stop the operation of air swing.
CAUTION
—4—