Sony SNC-M3 Quick Start Manual page 4

5
Install the IP Setup Program from
the CD-ROM
This section explains how to install the IP Setup Program
from the CD-ROM supplied with the camera. The IP Setup
Program is required for detecting the camera.
The other supplied programs can be installed in the same
procedures.
Utility programs stored in the CD-ROM
The following utility programs are stored in the supplied
CD-ROM.
Program Function
IP Setup Program Allows detection and set up of Sony
network cameras in the network.
SNC Audio upload tool Allows output of the sound picked up
by the microphone connected to the
computer from the speaker built in
the SNC-M1/M1W/M3/M3W network
camera.
Easy recording software
An easy-recording software program, "Network Camera
Recorder," is available for the SNC-M1/M1W/M3/M3W
network cameras.
"Network Camera Recorder" allows manual or scheduled
recordings of camera images and the sound picked up by the
microphone built in the camera.
For more information on "Network Camera Recorder," access
URL: (for customers in Europe)
http://www.sonybiz.net/software/m-series
1
Insert the CD-ROM disc into the CD-
ROM drive of your computer.
2
Click the "IP Setup" icon of IP Setup
Program.
Click.
3
Click "Open."
The IP Setup Program starts and Welcome dialog
appears.
Note
If you click "Save this program to disk," you cannot install
correctly.
In this case, delete the downloaded file, and click the "IP
Setup" icon again.
4
Install the IP Setup Program from the CD-ROM
4
Click "Next."
5
Read the Software License Agreement
carefully and click "Yes" to accept the
agreement.
6
Select the destination folder in which
to install the program and click "Next."
The default setting is "C:\...\SONY\IP Setup
Program."
Click.
Click.
1
The
destination
folder is
displayed.
2
Click.