Omron H7CZ-L8 Manual page 10

H7CZ
Operating Procedures
Setting Procedure Guide
Change to Function Setting Mode.
Power ON
Run mode
*1. If the mode is switched to the function setting mode during operation, operation will continue.
*2. Changes made to settings in function setting mode are enabled for the first time when the mode is changed to run mode. Also,
when settings are changed, the counter is reset (present value initialized and output turned OFF) on returning to run mode.
Input mode
(CNTM)
Output mode
(OUTM)
Output
time
(OTIM)
Counting
speed
(CNTS)
Prescale
value
(PSCL)
From next page To next page
10
For details on operations and display in run mode, refer to page 13.
* 1
3 s min.
The display depends on the selected configuration.
Function
setting mode
* 2
3 s min.
The characters displayed in reverse video are the default settings.
• Set the input mode using the U Key.
up down
(UP) (DOWN)
• Set the output mode using the U Key.
n f c
(N) (F) (C)
• Set each digit using the individual U Key.
0.01 0.50 99.99
(0.01 s) (0.50 s) (99.99 s)
Note: Displayed only when the output mode is C, R, K-1, P, Q, or A.
• Set the counting speed using the U Key.
30hz
(30 Hz) (5 kHz)
• Set the Reset input signal width using the U Key.
Reset input
signal width
20ms 1ms
(IFLT)
(20 ms) (1 ms)
• Set the decimal point position using the U Key.
Decimal
point position
(DP)
(One digit after
(No decimal
decimal point)
point)
• Set each digit using the individual U Key.
0.001 1.000
(0.001) (1.000)
k-1
r p q a
(R) (K-1) (P) (Q) (A)
(Two digits after (Three digits after
decimal point) decimal point)
99.999
(99.999)