Table of Contents
Advertisement
E ACCESS indicator
Lights in orange while the HDD is being
accessed.
For more information on this indication, see "Status
Indications" (page 20).
F DC IN (DC power input) connector
Supply power to this unit by connecting the
DC power output cord that is supplied with
the BC-U1 battery charger. Attach the
protective cover when this connector is not
in use.
G Power switch
Power the unit on by pressing the switch for
about three seconds. Power the unit off in
the same way, by pressing the switch for
about three seconds.
H USB connector
Connect to the camcorder or recorder using
the PHU connection cable. Also, connect to
video editing equipment using a USB cable.
I Attachment ring
Attach the shoe adaptor when installing this
unit on the camcorder.
For more information on installation, see
"Installing on the Camcorder" (page 13).
12
Preparations
Preparations
Mounting the Battery Pack
Use this unit with a battery pack mounted.
The BP-U30 Battery Pack is recommended.
You can also use the BP-U60 Battery Pack,
but be sure to observe the following
precautions when doing so.
• Depending on the installation position,
this battery pack may interfere with
operation of the camcorder.
• The BP-U60 is heavier than the BP-U30.
If this unit should be dropped with the
BP-U60 mounted, the impact is greater
than when the BP-U30 is mounted.
Handle this unit with care, being careful
not to drop it or allow it to tip over.
Note
This unit does not have a recharging
function. Before mounting the battery pack,
charge it with the special BC-U1 Battery
Charger.
For information on how to charge the battery pack,
refer to the Operating Instructions of the BC-U1.
Advertisement
Table of Contents
