Table of Contents
Advertisement
7.1.2 Remote panel
GB
D
F
I
16
5 5
4 4
3 3
2 2
1 1
6 6
1) Compressor LED (GREEN):
LIT: the compressor is running.The unit is cooling.
FLASHING: the compressor is a delayed start mode.
OFF: the compressor is OFF. The required room temperature has been reached
.
2) Evaporator fan LED (GREEN):
LIT: Evaporator fan is running.
FLASHING: the evaporator fan is in a delayed start mode.
OFF: Evaporator fan is off.Unit in Defrost mode.
3) Defrost LED (YELLOW):
LIT: automatic or manual defrost in progress.
4) Alarm LED (RED):
LIT: Alarm mode: malfunctioning of a sensor, or intervention of pressure-stat
or room temperature outside preset limits.
OFF: Unit working normally.
5) DISPLAY: When the machine is not in operation, the label "OFF" and the cell
temperature are intermittently displayed one after the other on the digital display.
When the machine is in operation, during the normal working cycle, the display
indicates the cell temperature. Parameters being set will be displayed during
programming. A "Fault Code" will be displayed during alarm mode.
6) "SET" KEY. Permits entry of room temperature requirements.
7) "DOWN" KEY. Key to decrease data values.
8) "MAN.DEFR./UP" KEY. Key to increase data values.
Press for 8 seconds at least to initiate manual defrost as well.
9) Key "T.A.A." Key to mute audible alarm.
This alarm is not fitted as standard to the unit but can be added by the client.
To connect use the free terminals 1 & 2 (volt free) on the internal electronic
panel. Terminal 2 should have a live feed brought to it.
10) "ON/OFF" KEY.Main switch.
11) "LAMP" KEY.Push to turn room lamp ON/OFF.A red LED lights when lamp is
ON.
9 9
1 1 0 0
7 7
8 8
1 1 1 1
Advertisement
Table of Contents
