Sony VPL-DX10 Operating Instructions Manual page 21

For details, see "To Freeze the Image
Projected (Freeze)" on page 37.
Before using the Remote
Commander
Pull out the clear film from the lithium
battery holder.
To replace a battery
1
Pull out the battery cover by a thin
stick inserting to a hole, as shown the
illustration.
2
Install the lithium battery.
3
Put the lithium battery holder back
into the Remote Commander.
Notes on the lithium battery
• A button type lithium battery (CR2025) is
used in the Remote Commander. Do not
use batteries other than CR2025.
• Keep the lithium battery out of the reach of
children.
• Should the battery be swallowed,
immediately consult a doctor.
Notes on Remote Commander
operation
• Make sure that nothing obstructs the
infrared beam between the Remote
Commander and the remote control
detector on the projector. Direct the
Remote Commander toward the remote
control detector.
• The operation range is limited. The shorter
the distance between the Remote
Commander and the remote control
detector is, the wider the angle within
which the commander can control the
projector becomes.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent
type recommended by the manufacturer.
When you dispose of the battery, you must
obey the law in the relative area or country.
Rear
Face the +
side up.
Remote Commander
21