Sony VPL-CX125 Network Operating Instructions page 28

Sony operating instructions data projector vpl-cx155/cx125, vpl-cw125
Hide thumbs Also See for VPL-CX125:
Table of Contents

Advertisement

Message
Unable to switch
resolution of PC desktop.
LAN Module with same
network address exists.
LAN Module
disconnected while
connecting.
System error/Quit
Projector Station for Air
Shot Version 2
The same IP Address
already exists.
Projector connection
error.
Projector connection
failure.
28
Others
PC PJ Cause and Remedy
a
• When the screen resolution of the computer is not
identical with the projector LCD panel resolution, and
when the computer is connected to the projector with
[Set PC desktop to Projector resolution] of the [Option
Setting]-[Connection Setting] checked, the resolution
switching of the computer cannot be done successfully.
c If the message appears every time the computer is
connected to the projector, uncheck [Set PC desktop to
Projector resolution].
a
• The IP address on the same subnet mask which is used
by the LAN module for the network has been assigned
to another LAN module.
c Check the IP Address Setting of the LAN module used
with the Projector Station for Air Shot Version 2 and
that used in the computer. Then change the settings so
that their network addresses are not identical.
a
• While the computer is connected to the projector, the
LAN module is removed.
c If the USB or LAN module of PCMCIA is removed
during connection, the computer may become unable to
establish proper connection with the projector. To
remove the USB or LAN module of PCMCIA, make
sure to disconnect the device.
a
• Because of the lack of system resources in the computer,
you cannot start the Projector Station for Air Shot
Version 2 properly.
c Restart Windows and start the Projector Station for Air
Shot Version 2.
a a
• The set IP address is already in use.
c Input a new IP address.
a
• The network condition is not good.
c Consult a network administrator.
a
• When two or more projectors are connected, the image
cannot be projected because the resolution of the second
or subsequent projector is lower than that of the first.
c Connect the projectors in order of lower to higher
resolution.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vpl-cw125Vpl-cx155

Table of Contents