Turning Off The Power - Sony VPL-CX100 Operating Instructions Manual

adjustment is performed at the same
time. If you do not want to perform the
automatic keystone adjustment, set the
"V Keystone" to "Manual." (See
page 41.)
• If you set the "V Keystone" to "Auto,"
the "V Keystone" correction is
automatically adjusted. However, it may
not be perfectly adjusted depending on
the room temperature or the screen
angle. In this case, adjust it manually.
Press the KEYSTONE key to "V
Keystone" displays on the screen, and
adjust the value with the v/V/b/B keys.
• Be careful not to let the projector down
on your fingers.
• Do not push hard on the top of the
projector with the adjuster extended. It
may cause a malfunction.
7
Adjust the size of the picture and the
focus.
Adjust the picture size using the Zoom
ring and adjust the picture focus using
the Focus ring.
28

Turning Off the Power

Turning Off the
Power
1
Press the ?/1 key.
"POWER OFF? Please press ?/1 key
again." appears to confirm that you want
to turn off the power.
Note
The message disappears if you press any
key other than the ?/1 key, or if you do not
press any key for five seconds.
2
Press the ?/1 key again.
The ON/STANDBY indicator flashes in
green and the fan continues to run to
reduce the internal heat. During this
time, you will not be able to light up the
ON/STANDBY indicator again with the
?/1 key.
3
Unplug the AC power cord from the
wall outlet after the fan stops running
and the ON/STANDBY indicator
lights in red. (Except when using the
Direct Power On/ Off function.)
When you cannot confirm the on-
screen message
When you cannot confirm the on-screen
message under certain conditions, you can
turn off the power by holding the ?/1 key for
about one second instead of the steps 1 and
2 above.