Operating Video Equipment - Sony KP-41T35 Operating Instructions Manual

MDP manufacturer code numbers
Manufacturer
Sony
Kenwood
Magnavox
Maranz
Mitsubishi
Panasonic
Philips
Pioneer
RCA
Sanyo
Sharp
Yamaha
Notes
• If more than one code number is listed, try entering them one
by one, until you come to the correct code for your equipment.
• In some rare cases, you may not be able to operate your non-
Sony video equipment with the supplied remote control. This
is because your equipment may use a code that is not included
with this remote control. In this case, please use the
equipment's own remote control unit.
• The code numbers for Sony equipment are assigned at the
factory as follows:
VHS VCR 301 (preset code for the supplied
8 mm VCR 302
Beta, ED Beta VCRs 303
• Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code number may
revert to the factory setting and must be reset.
36 -EN
Operations
Code number
701
707
703
702
702
704
703
702
702
706
705
703
remote control)

Operating video equipment

VTR (FUNCTION)
Video operating
buttons
1
4
7
Use the video operating buttons on the remote
control to operate the video equipment.
Press VTR (FUNCTION) before operating the
video equipment.
Operating a VCR Buttons on the remote control
To turn on or off Press VTR (POWER).
To select a channel Press the 0 – 9 buttons.
directly
To change channels Press CH +/–.
To record Press ( while pressing r. First release
(, then release r.
To play Press (.
To stop Press p.
To fast forward Press ).
To rewind the tape Press 0.
To pause Press P.
To resume normal playback, press again.
To search the picture Press ) or 0 during playback.
forward or backward To resume normal playback, release the
button.
To change input mode Press TV/VTR.
Buttons on the remote control
Operating an MDP
To turn on or off Press VTR (POWER).
Press (.
To play
To stop Press p.
To pause Press P.
To resume normal playback, press again.
To search the picture Keep pressing ) or 0 during
forward or backward playback.
To resume normal playback, release the
button.
Press CH +/–.
To search the chapter
forward and backward
Note
• If the video equipment does not have a certain function, the
corresponding button on this remote control will not operate.
VTR (POWER)
2 3
5 6 0 – 9 buttons
8 9
ENTER
0
CH +/–