Programming The Remote Control - Sony Qualia 006 Owner's Manual

Using the Remote Control

Programming the Remote Control

64
The remote control is preset to operate Sony brand video equipment.
Function
DVD/VCR
SAT/CABLE
i.LINK
If you have video equipment other than Sony brand that you want to control
with the SXRD projection TV's remote control, use the following procedure
to program the remote control.
✍
The equipment must have infrared (IR) remote capability in order to be
used with the remote control.
1
Turn to the list of "Manufacturer's Codes" on page 65, and find the
three-digit code number for the manufacturer of your equipment. (If
more than one code number is listed, use the number listed first.)
2
FUNCTION
Press
i.LINK indicator lights up.
3
SAT/CABLE
Press
input flashes.
4
While the desired indicator is flashing, enter the three-digit
manufacturer's code number.
5
Press ENTER.
✍
You must do step 5 within 10 seconds of step 4, or you must redo
steps 4 through 5.
6
To check if the code number works, aim the SXRD projection TV's
remote control at the equipment and press
corresponds with that equipment. If it responds, you are done. If not, try
using another code listed for that manufacturer.
✍
If more than one code number is listed, try entering them one by one
until you come to the correct code for your equipment.
✍
If you enter a new code number, the code number you previously entered
at that setting is erased.
✍
In some cases, you may not be able to operate your equipment with the
supplied remote control. In such cases, use the equipment's own remote
control unit.
✍
Whenever you remove the batteries to replace them, the code numbers
may revert to the factory setting and must be reset.
Equipment
Sony DVD player
Sony Satellite Receiver
Sony DVD player (i.LINK)
repeatedly until the DVD/VCR, SAT/CABLE or
for five seconds until the indicator of the selected
Programmable Code
Number
751
801
901
SAT/CABLE that