Initial Operation; Fitting/Changing The Saw Blade; Fitting The Guide Fence; Connecting The Sawdust Extraction Appliance - Parkside PSTK 800 B2 Translation Of Original Operation Manual

Initial operation

Fitting/changing the saw blade

Always remove the plug from the power socket
before working on the appliance .
♦ Remove the pivoting guard
♦ Turn the quick-release chuck
this position .
♦ Press the required saw blade into the quick-
release chuck as far as the limit stop .
♦ Release the quick-release chuck
return to its initial position . The saw blade is
now locked .
■ WARNING! The saw blade teeth must point
forwards at this point (see foldout page)!
♦ Replace the pivoting guard
device .

Fitting the guide fence

The guide fence can be fixed on the left or right
of the appliance .
♦ Undo both the clamping screws on the insertion
openings .
♦ Push the guide fence
ings .
♦ Retighten the two clamping screws .
Connecting the sawdust extraction
appliance
♦ Push the reducer
until it is secured .
♦ Attach an approved dust and sawdust extractor
to the reducer or extraction connector
directly .
■ 6 │ GB │ IE │ NI
.
and hold it in
– it must
back onto the
into the insertion open-
into the extraction connector

Fitting the splinter guard

The splinter guard can prevent the tearing up of
the surface when sawing wood . The splinter guard
can only be used with certain sawblade types
and only at a cutting angle of 0° .
♦ Press the splinter guard
from below (arrow facing upwards) .

Operation

Setting the cutting angle

♦ Push the clamping lever
baseplate to the front .
♦ Adjust the cutting angle to 0°/ 22,5°/ 45° with
the aid of the markings on the baseplate
Push the baseplate
locking pin engages in the toothing
♦ Push the clamping lever
NOTE
► With a cutting angle of 22,5°/ 45°, the pivoting
guard must be removed beforehand! If the
baseplate cannot be locked well by clamping
lever , remove the extraction connector
then tighten the clamping screw

Setting the stroke rate

♦ Use the stroke rate preselection adjusting
wheel to set the required stroke rate .
into the sliding shoe
forward and pull the
.
to the rear so that the
.
backwards .
,
with hex key .
PSTK 800 B2