Troubleshooting - Bissell 8804 Series User Manual

To Install The Replacement Pump Belt
With the unit still on its side, loop one end of the
1.
replacement pump belt around the red pump pulley and then
the other end around the silver motor shaft (see illustration).
Do not twist the replacement pump belt.
Re-install the toothed brush belt first onto the red pump pulley
2.
and then onto the toothed end of the brush (see Illustration).
Re-install the brush into the base of the unit.
3.
Place the black brush arm onto the brush and slide black
4.
brush arm into base of unit. The black brush arm and brush
should slide easily into original position (see illustration).
Re-install the red retainer plate and Phillips head screw
5.
(see illustration).
Using your finger, gently spin the replacement pump belt on
6.
the silver motor shaft. If assembled correctly, the replacement
pump belt should rotate freely around the silver motor shaft
and drive pulley without obstruction. The brush should also
rotate freely when the silver motor shaft is turned.
Turn the machine right side up and replace the Tank-in-Tank,
7.
Smart Mix tank and belt access door (see illustration).
Assembly is now complete.
8.
If you have any questions, or are having trouble installing
your replacement pump belt, please call BISSELL Consumer
Services at 1-800-237-7691.

Troubleshooting

Reduced Spray Or No Spray.
Possible Causes
Bladder may be empty.
1
SmartMix tank may be empty.
2
The Flow Indicator Filter may be clogged.
3
Tank-in-Tank may not be seated properly.
4
Pump may have lost prime.
5
ug310-5926_1697_1205.indd 13 ug310-5926_1697_1205.indd 13
1.
2.
4.
6.
7b
WARNING:
To reduce the risk of fire,
electric shock or injury,
unplug appliance from outlet
before servicing.
Remedies
Turn power OFF; refill tank with
1
hot tap water.
Turn power OFF; clean out lint
2
screen, follow SmartMix instructions
on page 6.
Clean Out Filter; follow Steps under
3
Maintenance/Storage on page 12.
Turn power OFF; remove tank and
4
check gasket on tank bottom,
reseat tank.
Turn power OFF; after 1 minute, turn
5
ON and depress Spray trigger.
3.
5.
7a
13
12/21/05 3:51:42 PM 12/21/05 3:51:42 PM