Table of Contents
Advertisement
RUGGEDCOM WIN5114-V
Installation Guide
12VDC Port
ANT 1 and ANT 2 Ports
RSSI LEDs
W.LINK LED
PWR LED
ETH Port
Chassis Ground Connection
Section 1.3
Required Tools and Materials
The following tools and materials are required to install the RUGGEDCOM WIN5114-V:
Tools
• Wrench or socket set
• Phillips screwdriver
• Drill with an 8 mm (5/16 in) drill bit
• Wall anchors (if necessary)
Required Tools and Materials
A 4-pin, female, D-Coded M12 port for power. For more information about connecting data
and power, refer to
Section 2.7, "Connecting Power and
Ports for connecting primary and secondary external antennas. For information about
connecting the antennas, refer to
Indicates the received signal strength.
LED
Indicates when the subscriber unit is connected with a base station.
State
Green (Solid)
Green (Blinking)
Indicates when power is supplied to the subscriber unit.
State
Green
Off
A 4-pin, female, D-Coded M12 port for data.
Protects the subscriber unit from power surges and accumulated static electricity. For
information about grounding the subscriber unit, refer to
Subscriber
Unit".
Greases
• Marine grease (for marine applications only)
Tapes
• POE cold shrink (maximum 49.2 mm or 1.9 in inner
diameter before shrinking) or self-amalgamating tape
Data".
Section 2.5, "Installing the
Antennas".
RSSI Level
< -90
-85 to -90
-80 to -85
-75 to -80
-70 to -75
-65 to -70
-20 to -60
> -20
Description
Subscriber unit is connected to the base
station and receiving services.
Link between the subscriber unit and the
base station is down.
Description
Power is on.
Power is off.
Section 2.6, "Grounding the
Chapter 1
Introduction
3
Advertisement
Table of Contents
