Sony UP-DR100 Instructions For Use Manual page 15

Identification of the printing pack currently
being used on the information display
Display on the
information display
R35
R46
R57
R68
Notes
• Turn the printer on first.
• Don't turn the printer on again within 5 seconds
after turning it off.
• Do not turn the computer off and on again while
it is accessing a hard or floppy disk.
2
Send the image data from the computer to be
printed.
The printer starts printing.
1 While the printer is receiving the image data,
the following message should appear.
Indicates the image data is being
transferred.
: Indicates 20% of the total amount of image
data. In the above example, 60% of the total
amount of image data has been transferred.
2 The printer starts printing the transferred image
data as soon as the print command is sent from
the computer.
The PRINT indicator lights and the following
message should appear.
Number of pages to be printed
The color indication changes as the color printing
procedes:
StarttYELLOWtMAGENTAtCYANtLAMIt
Finsih.
Printing pack
UPC-R35/R35A
UPC-R46/R46A
UPC-R57/R57A
UPC-R68A
3 After printing is finished, the printed paper is
ejected from the output slot.
The printing time depends on the print size, ink
ribbon and the paper.
Once printing has been completed, the PRINT
indicator goes off and READY appears on the
information display again.
Note
Do not open the maintenance door while the printer is
printing. Doing so may have an influence on the quality
of the printout.
To stop sending the image data or to stop
printing midway
Press and hold the FEED button for more than one
second. The page currently being printed is completed
and ejected. After the printout is ejected, the information
display returns to READY. The image data stored in the
memory and the number of printings set in the queue are
cancelled.
About memory
Since the printer has memory for image data spooling,
image data to be printed can be transferred to the printer
while printing an image.
15
Printing from the Computer