National Instruments DAQPad-6508 User Manual page 90

L
LabVIEW and LabWindows/CVI
software, 1-3
LED patterns for DAQPad-6507/6508 states
common questions, C-2
description (table), 2-3
low DIO state, 3-10 to 3-11
M
manual. See documentation.
mode 1 input timing (figure), 3-13
mode 1 output timing (figure), 3-14
mode 2 bidirectional timing (figure), 3-15
N
NI-DAQ Configuration Utility, C-1
NI-DAQ driver software, 1-4 to 1-5
overview, 1-4
relationship with programming
environment (figure), 1-5
version required for DAQPad-6507/6508
devices (note), 2-1
O
OBF* signal
description (table), 3-12
mode 1 output timing (figure), 3-14
mode 2 bidirectional timing (figure), 3-15
OKI 82C55A data sheet, B-1 to B-17
operation of DAQPad-6507/6508 devices. See
theory of operation.
© National Instruments Corporation
P
physical specifications, A-2
pin assignments
cable assembly connectors
pins 1 through 50 (figure), 3-5
pins 51 through 100 (figure), 3-6
I/O connector pin description (figure), 3-2
Port C pin assignments, 3-4
Plug and Play configuration, 2-4
polarity selection, resistors used (note), 2-3
Port A (PPI A), 3-7
Port B (PPI C), 3-7
Port C pin assignments (figure), 3-4
power, connecting to digital I/O lines, 3-8
power considerations, 2-4 to 2-5
connections between computer or USB
hub and DAQPad device (figure), 2-2
damage due to incorrect connections
(caution), 3-8
methods for turning off DAQPad, 2-5
power connections, 3-8
power requirement specifications, A-2
self-resetting fuse, 3-8
suspend mode, 2-4 to 2-5
PPI A (Port A), 3-7
PPI C (Port B), 3-7
Q
questions and answers, C-1 to C-2
digital I/O, C-2
general information, C-1
installation and configuration, C-1 to C-2
R
RD* signal
description (table), 3-12
mode 1 input timing (figure), 3-13
mode 2 bidirectional timing (figure), 3-15
requirements for getting started, 1-2
I-3 DAQPad-6507/6508 User Manual
Index