Sony DPP-EX50 Operating Instructions Manual page 111

Check
Symptom
The date cannot
• Is "Date Print" set to
be printed.
"On"?
• Does the image support
DCF?
The date is • Is "Date Print" set to
printed "Off"?
unintentionally.
• Was the date saved with
the image when it was
shot with the digital
camera.
• Did you set "Borders" in
The image cannot
the SET UP menu to
be printed fully
"Yes"?
in the print
range.
• Do you feed the print
paper in the correct
direction?
• Is the aspect ratio of the
image correct?
• Is the image edited and
Even if I set
saved with "Borders" set
"Borders" to
to "Yes."
"No," the image
is printed with
borders on both
sides.
• Did you set "Borders" in
Only part of an
the SET UP menu to "Yes"?
image is printed.
Cause/Solutions
c Set "Date Print" in the SET UP menu to
"On." (.page 62)
cThe "Date Print" function of this unit
supports an image that is compatible
with the DCF standards.
c Set "Date Print" in the SET UP menu to
"On." (.page 62)
c Change the camera settings.
c Set "Borders" to "No" by selecting
Menu - SET UP - Borders. (.page 61)
c Place the print paper in the direction of
the arrow. (.page 16)
c Depending on the type of digital camera
used, the aspect ratio of the recorded
image differs, so the image may not be
printed covering the entire printable
area.
c When you edit and save an image in the
postcard or 3.5 x 5 inch size, it is saved as
a print image including the blank areas.
Even if you print it with "Borders" set to
"No," you cannot eliminate the borders
on both sides of a print. To print without
borders, edit and save an image with
"Borders" set to "No." (.page 61)
c Set "Borders" to "Yes" to print the whole
area of an image. (.page 61)
GB
111