Hp Parallel Interface Configuration - HP 400 Series Servicing Manual

LAN Interrupt Level
Enter the LAN menu's interrupt level by typing the command 2. Then the prompt line
changes to
2 Interrupt Level
Type 3, 4, 5 or 6 RETURN ?
Type the command to change the LAN interrupt level, then exit the LAN menu.
C.4.8

HP Parallel Interface Configuration

Enter the HP Parallel Interface menu from the Interface menu by typing the command
key for the HP Parallel Interface. The following menu appears:
HP PARALLEL
Key Feature
------------------------
1 Select Code
2 Interrupt Level
X to exit menu
------------------------
Type [key] RETURN ?
HP Parallel Select Code
Type the command 1 to get this select code prompt:
1 Select Code
used select codes are :
10 14 15 21
Type 0.. 31 except used RETURN ?
You can type the command for any unused select code. The menu changes to reflect the
new select code.
HP Parallel Interrupt Level
Your HP Parallel interrupt level is accessed by typing the command 2. Then, the
prompt changes to
2 Interrupt Level
Type 3, 4, 5 or 6 RETURN
Type the command for the new select code. Then, exit the menu.
5
Value
23
3
23
3
Configuring the EEPROM C-23