IMPORTANT INFORMATION
EB101030
LOCK WASHERS/PLATES AND COTTER PINS
1. Replace all lock washers/plates
pins after removal. Bend lock tabs along the
bolt or nut flats after the bolt or nut has been
tightened to specification.
EB101040
BEARINGS AND OIL SEALS
Install bearings and oil seals so that the manu-
facturer's marks or numbers are visible. When
installing oil seals, apply a light coating of light-
weight lithium base grease to the seal lips. Oil
bearings liberally when installing, if appropriate.
Oil seal
CAUTION:
Do not use compressed air to spin the bea-
rings dry. This will damage the bearing surfa-
ces.
Bearing
EB101050
CIRCLIPS
1. Check all circlips carefully before reassembly.
Always replace piston pin clips after one use.
Replace distorted circlips. When installing a
circlip
, make sure that the sharp-edged
corner
is positioned opposite the thurst
it receives. See sectional view.
Shaft
3
GEN
INFO
and cotter