Table of Contents
Advertisement
PRODUCT MANUAL
Section
Title
15
Magnetic Effect
16
Power Input
16.6
Normal Operating Conditions (dc)
16.6.1.1b(1,2)
Voltage (Average Value dc)
16.6.1.1b(3)
Emergency Operation
16.6.1.2
Ripple Voltage (dc)
Momentary Power Interruptions
16.6.1.3
(dc)
16.6.1.4
Normal Surge Voltage (dc)
Engine Starting Under Voltage
16.6.1.5
Operations (dc)
Abnormal Operating Conditions
16.6.2
(dc)
16.6.2.1
Voltage Steady State (dc)
Low Voltage Condition (dc)
16.6.2.2
(Category B Equipment)
Momentary Undervoltage
16.6.2.3
Operation
16.6.2.4
Abnormal Surge Voltage (dc)
16.7
Load Equipment Influence (dc)
16.7.5
Inrush Current Requirements
16.7.7
DC Current Ripple tests (dc)
17
Voltage Spike
Audio Frequency Conducted
18
Susceptibility - Power Inputs
19
Induced Signal Susceptibility
Radio Frequency Susceptibility
20
(Conducted and Radiated)
Emission of Radio Frequency
21
Energy
(Conducted and Radiated)
Lightning Induced Transient
22
Susceptibility
23
Lightning Direct Effects
25
Electrostatic Discharge (ESD)
A V I A T I O N
Category
Details - EMI
Z
0<D<0.3m
ZXX
28Vdc Equipment.
-
-
Z
30.3VDC, 22VDC
X
No test performed.
Z
Refer to DO-160 § 18.3.1
50mS, 200mS and 1S. § 16.6.1.3(b) digital circuits and (c) all equipment apply.
Z
Equipment reset permissible but shall auto-recover
28Vdc for 5min. then 50Vdc for 50ms then return to 28Vdc for 5s reduce to 12Vdc
Z
for 30ms then return to 28Vdc for 5s. Perform 3 cycles. 1ms rise and 5ms fall
times. No degradation of performance permissible.
Decrease nominal voltage to 10Vdc, then increase 0.3V/s for 35-sec, then nominal.
Z
Equipment reset permissible but shall auto-recover
-
-
32.2Vdc (max), 20.5Vdc (min)
Z
Must meet PVT requirements with no manual intervention when returned to
+28VDC
1 min. at 28Vdc then 1 min. @ 20Vdc then ramp to 0Vdc over 10 min. Return to
28Vdc and determine compliance. It shall be demonstrated there is no undesirable
B
behavior in the range from minimum voltage to zero. No manual intervention is
allowed. Must auto-recover.
Z
12Vdc for 7-sec (Pass = Equipment reset permissible but shall auto-recover)
Surges of 80Vdcf or 100ms & 48Vdc for 1s. May have degraded performance
Z
during the exposure, but must recover and meet PVT requirements after. No
manual intervention is allowed.
-
X
No test performed.
X
No test performed.
A
600Vdc Voltage Spike. No susceptibility shall be observed.
Z
Fig. 18-3 for 28Vdc systems. No susceptibility shall be observed.
AC
Table 19-1 - Cat AC. No susceptibility shall be observed.
TT
Level TT, No susceptibility shall be observed.
The 107840 is a radio emitter and will have energy in the RF spectrum between
M
2.40 GHz and 2.48 GHz
Pin Injection
Cable Bundle E3 , qualified by test
XXE3XX
Burst
May have degraded performance during the exposure, but must recover and meet
PVT requirements after. Manual intervention is allowed.
XXXX
No test performed.
(10 pulses) 15kV pulses positive (+) polarity, (10 pulses) 15kV pulses negative (-)
polarity
A
May have degraded performance during the exposure, but must recover and meet
PVT requirements after. No Manual intervention is allowed.
Table 3: DO-160G Qualification Form – EMI
Size
Doc Type
A
PM
107840-XXXX-XXXXXPM
107840 Bluetooth Audio Interface
XX , no test performed
XX , no test performed
Drawing Number
Rev
Date
Page
3
04/11/19
25
of
25
Hide quick links:
Advertisement
Table of Contents
