Commissioning And Operation; Operating Conditions - Omega TCL-3M165E2 Series User Manual

Series TCL-3M165E2
4

Commissioning and operation

CAUTION! Risk of injury or material damage!
The calibrator can become very hot during operation. If the calibrator is operated without
supervision, third-party persons in the vicinity could get injured. Moreover, flammable
material could get into the calibrator and cause significant damage to property.
 Never leave the calibrator unattended when it is in operation or in the cooling phase.
For safe operation of the calibrators of the TCL-3M165E2 series, a proper commissioning
procedure is necessary.
Commissioning includes the installation, the electrical connections, the preparation for the
test task as well as correct switching on and off of the calibrator.
Further, a visual inspection for damage is required before use.
The required steps are described in the following sections.
IMPORTANT!
Please also follow the instructions for intended use ( § 1.2), the safety instructions
( § 2) and the information on the ambient conditions ( p. 56).

4.1 Operating conditions

Select a safe installation site for commissioning the calibrator.
Installation site and operating position:
 Only suitable for indoor use, do not use outdoors.
 Operate only in the vertical position on an even surface. The surface must be stable,
clean, and dry.
If the operation positions do not conform to the above, the structural safety and the
specified properties of the calibrator are not guaranteed.
 At higher testing temperatures, please use a sufficiently big, fire-resistant supporting
surface.
 Sufficient clearance around the calibrator
On the front side > 1 m, behind and to the sides > 0.5 m. Head clearance and sufficient
clear space above the calibrator.
 Sufficient ventilation must be ensured.
 Do not operate in the vicinity of flammable materials.
 Do not install in a cupboard or other similar location.
 The ventilation openings must not be blocked or covered.
 The calibrator must be installed so that it can be switched off at any time.
IMPORTANT! "KILL" switch!
The plug of the power connecting cable serves as a "KILL" switch.
 Ensure that the plug is always easily accessible and easy to reach.
 In an emergency, pull the plug, so that the calibrator is isolated from the power.
Technical changes reserved
Commissioning and operation
- 15 -