Asus P5QL Manual page 32

2. Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. Connect
the S/PDIF Out module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
P5QL Digital audio connector
The S/PDIF module is purchased separately.
3. Serial ATA connectors (7-pin SATA1-6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.
P5QL SATA connectors (ICH10R
Connect the right-angle side of SATA
signal cable to SATA device. Or you
may connect the right-angle side of
SATA cable to the onboard SATA
port to avoid mechanical conflict with
huge graphics cards.
1-22
P5QL
P5QL
SPDIF_OUT
SATA6 SATA4
SATA5 SATA3
)
®
right angle side
SATA2
SATA1
Chapter 1: Product introduction