Special Mode Setting Button - Denon AVR-3312 Service Manual

SPECIAL MODE

Special mode setting button

b No.1 - 10, 12 : Press the ON/STANDBY button to turn on the power while pressing both the button A and the button B at the same
time.
b No.11 :
Press and hold both buttons A and B for over 3 second with the power turned on.
No. Mode
Version display
1
(μcom/DSP Error Display)
2 Displaying the protection history mode
IInitialization mode
3
(Remove settings for Installer Setup.)
IInitialization mode
4
(Includes settings for Installer Setup.)
Mode for switching tuner frequency step
5
(E2 model Only)
Mode for preventing remote control
6
acceptance
7 Panel lock mode
Panel lock mode
8
(Master volume is not locked.)
9 Cancellation of panel lock mode
10 Diagnostic mode
11 Remote ID Setup mode
12 Installer Setup mode
NOTE:
If " REC " is displayed on the fluorescent display, the set is in the special developer's mode and the RS-232C
communications are not possible.
Turn on the power, then press and hold down the "PRESET CHANNEL 2" and " STATUS " buttons for over 3 seconds to
turn off " Q " on the display. RS-232C communications are now enabled.
d
Button A
TUNER
PRESET CH +
TUNER
PRESET CH -
PRESET
CHANNEL 2
PRESET
CHANNEL 1
ZONE3
SELECT
PRESET
CHANNEL 1
PRESET
CHANNEL 2
PRESET
CHANNEL 2
TUNER
PRESET CH -
PRESET
CHANNEL 1
PRESET
CHANNEL 1
ZONE2/REC
SELECT
ZONE3 SELECT
ZONE2/REC SELECT
INTERNET RADIO
ON/STANDBY
DIMMER
Button B
Firmware versions such as Main or DSP are displayed in the FL
STATUS
manager. Errors are displayed when they occur. (Refer to 17 page)
The protection history is displayed.
STATUS
(Refer to 20 page)
PRESET Backup data initialization is carried out.
CHANNEL 3
(Remove settings for Installer Setup.)
PRESET Backup data initialization is carried out.
CHANNEL 2
(Includes settings for Installer Setup.)
Change tuner frequency step to FM:200kHz/AM:10kHzSTEP
iPod 1
Operations using the remote control are rejected.
INTERNET
(Mode cancellation: Turn off the power and execute the same
RADIO
button operations as when performing setup.)
Operations using the main unit panel buttons or the master volume
iPod 1
knob are rejected.
TUNER
Operations using the main unit panel buttons are rejected.
PRESET CH -
DIMMER Panel lock mode is cancelled.
This mode is used for confirming the Video and Audio (signal)
STATUS paths. (Troubleshooting)
The signal paths of the set can be easily confirmed after repair.
When using multiple DENON AV receivers in the same room, make
STATUS this setting so that only the desired AV receiver operates.(Refer to 22
page)
Access the Remote Maintenance mode via the internet.Installer
STATUS Setup is displayed on GUI/Option Menu.
b Refer to AVR_RemoteMaintenance_.pdf of SDI.
TUNER PRESET CH +,-
iPod 1
STATUS
PRESET CHANNEL 1,2,3
16
Contents