Mounting/Extending; Installing The Device - Siemens SIMATIC PN/BACnet LINK Operating Instructions Manual

Mounting/Extending

6.1

Installing the device

The PN/BACnet LINK can be mounted to a 35 mm standard mounting rail according to DIN
EN 60715 or installed on a control panel.
Information on the selection of the location of use as well as reliable mounting positions and
minimum clearances is available in the section Installation location (Page 46).
Mounting on a standard mounting rail
Follow these steps:
1. Mount the PN/BACnet LINK on the mounting rail.
2. Swivel the PN/BACnet LINK backwards until it engages audibly.
Figure 6-1
NOTICE
If the device is not installed on a control panel, the mounting sliders (see figure Control
panel mounting item
Otherwise, the mounting slides can deform if they are exposed to hot and moist ambient
conditions for long periods.
50
PN/BACnet LINK rail mounting
①
) must always be in the default positions set at the factory.
Operating Instructions, 10/2017, A5E39895543-AA
6
PN/BACnet LINK