Table of Contents
Advertisement
TRENDnet User's Guide
1. Log into your management page (see
8).
2. Click on the Management tab and click Backup/Restore Settings.
3. Click Load Default. If prompted, click Yes or Ok.
System Reboot:
Management > Backup/Restore Settings
You may want to restart your access point if you are encountering difficulties with your
access point and have attempted all other troubleshooting.
There are two methods that can be used to restart your access point.
i.
Turn the access point off disconnect the power source or press the power button
from the side of your access point (see
Use this method if you are encountering difficulties with accessing your access point
management page. This is also known as a hard reboot or power cycle.
OR
ii.
Access Point Management Page: This is also known as a soft reboot or restart.
1. Log into your management page (see
8).
2. Click on the Management tab and click Backup/Restore Settings.
3. Click Reboot under System Reboot to restart the access point. If prompted,
click yes or OK.
© Copyright 2018 TRENDnet. All Rights Reserved.
"Access the management
page" on page
"Product Hardware
Features" on page 3).
"Access the management
page" on page
Upgrade your firmware
Management > Upload Firmware
TRENDnet may periodically release firmware upgrades that may add features or fix
problems associated with your TRENDnet access point model and version. To check if
there is a firmware upgrade available for your device, please check your TRENDnet
model and version using the link.
http://www.trendnet.com/downloads/
In addition, it is also important to verify if the latest firmware version is newer than the
one your access point is currently running. To identify the firmware that is currently
loaded on your access point, log in to the access point, click on the Status tab and select
Main. If there is a newer version available, also review the release notes to check if
there were any new features you may want or if any problems were fixed that you may
have been experiencing.
i.
If a firmware upgrade is available, download the firmware to your computer.
ii.
Unzip the file to a folder on your computer.
Please note the following:
Do not interrupt the firmware upgrade process. Do not turn off the device
or press the Reset button during the upgrade.
If you are upgrade the firmware using a laptop computer, ensure that the
laptop is connected to a power source or ensure that the battery is fully
charged.
Disable sleep mode on your computer as this may interrupt the firmware
upgrade process.
Do not upgrade the firmware using a wireless connection, only using a
wired network connection.
Any interruptions during the firmware upgrade process may permanently
damage your device.
1. Log into your management page (see
8).
2. Click on Management, and click on Upload Firmware.
3. Depending on your web browser, next to Upgrade Firmware, click Browse or
Choose File.
4. Navigate to the folder on your computer where the unzipped firmware file
(.bin) is located and select it.
5. Click Open to start the firmware upgrade process. If prompted, click yes or OK.
TEW-826DAP
"Access the management
page" on page
47
Advertisement
Table of Contents
