Bissell 3760 Series User Manual page 12

Rotating Brush and Drive Belt Maintenance Continued
Place one end of the new Drive Belt over Motor Pulley and the
9.
other end over the Brush in the space between the bristles.
Pull the Brush firmly to stretch the Drive Belt and place ends
10.
of Brush down into slots on sides as shown. Turn Brush
several times by hand to center the Drive Belt.
Reposition Brush Cover and screws. Tighten
11.
screws securely.
TurboBrush Maintenance
Select Models Only
The TurboBrush should be checked regularly for clogs
or debris wrapping around the Brush Roll.
Unplug vacuum from electrical outlet.
1.
If a clog is present or debris is visible, unscrew the two
2.
screws on the back of the TurboBrush to remove the
faceplate and clear any obstructions.
To clean debris from the Brush Roll, remove the screw
3.
located on the Belt Cover. Lift the Belt Cover. Remove the
Brush Roll from the Drive Belt and clean debris.
Reposition the drive belt on the Brush Roll. Place ends
4.
of Brush Roll in slots on sides as shown. Reposition Belt
Cover and secure with shorter screw. Reposition faceplate
and secure with two longer screws.
12
ug603-5570_3760E_1105.indd 12 ug603-5570_3760E_1105.indd 12
WARNING:
To reduce the risk of electric
shock, turn Power Switch
OFF and disconnect plug
from electrical outlet before
performing maintenance or
troubleshooting checks.
Belt Cover
2/2/06 4:12:19 PM 2/2/06 4:12:19 PM