Bissell 3760 Series User Manual page 10

How to Maintain Your BISSELL Lift-Off Spinpower
To maintain maximum cleaning performance, the
following maintenance steps must be performed:
Empty the Dirt Container when the dirt reaches the "Full" line
1.
on the front.
Check the Upper Tank and Pre-Motor Filters at least once a
2.
month and clean and replace as needed.
Replace the HEPA Media Post-Motor Filter every six months.
3.
NOTE: More frequent Filter cleaning may be necessary
if you are vacuuming new carpet, fine dust, or have
allergy concerns.
Follow the instructions on the following pages to
perform these simple maintenance steps.
Empty Dirt Container
The Dirt Container needs to be emptied when the dirt
reaches the "Full" line on the front of the Container.
Unplug cleaner from electrical outlet.
1.
Slide the Lock 'n Seal Lever to the "Unlock" position.
2.
Grasp handle and pull the Dirt Container straight out to
3.
remove from vacuum.
Empty dirt into garbage container.
4.
Put the Dirt Container back in the vacuum and slide the lever
5.
to the "Lock" position.
Note: The Screens may also be removed from the side Dust
Chambers when you empty or clean the Dirt Container. The
Screens are made to fit each Dust Chamber. If they do not
slide down completely, try in the opposite Dust Chamber.
The Screens will also not fit if there is debris in the track.
The Dirt Container and Screens may be washed in warm
water with a mild detergent. Make sure they are completely
dry before replacing.
Cleaning The Upper Tank & Filter
Use only BISSELL Style 8 Replacement Filters in your
BISSELL Lift-Off Spinpower.
Unplug the cleaner from electrical outlet.
1.
The Upper Tank Filter can be reached by removing the Dirt
2.
Container, reaching underneath the Upper Tank and turning the
rim of the Filter Frame to unlock. Pull straight down to remove.
Brush the dirt off the Louvers and Upper Tank Filter.
The foam Upper Tank Filter may be removed and hand washed
3.
in cold water with mild detergent. Rinse well then air dry
thoroughly before replacing.
The Upper Tank and Louvers may also be wiped clean with a damp cloth.
4.
Note: For easier access, the entire Upper Tank may be
removed by turning the knob on the back of the cleaner to
10
unlock and pulling the entire tank straight out
ug603-5570_3760E_1105.indd 10 ug603-5570_3760E_1105.indd 10
WARNING:
To reduce the risk of electric
shock, turn Power Switch
OFF and disconnect plug
from electrical outlet before
performing maintenance or
troubleshooting checks.
Tip:
For maximum cleaning
performance, check and
clean or replace all Filters
as suggested.
Unlock
Position
Upper
Tank
Knob
.
Full Line
Lock
Position
Screen
2/2/06 4:12:17 PM 2/2/06 4:12:17 PM