York TIWM006B21S Installation And Maintenance Manual page 37

TIWM015B21S to TIWM030B21S
(1) Hold both ends of the flat panel and lift up.
Open and fully extend the flat panel and push the right arm shaft inward. After the shaft is separated
from the front panel, pull the flat panel forward with the right arm shaft slightly pushed inward and
remove the flat panel. Remove the lower right corner cover panel by pressing inward against both
ends.
Flat Panel
(2) Remove the three (3) screw caps and three (3) screws as shown. Pull the lower side of the front panel
(2 portions) forward to release the catch-fittings. Use a slotted screwdriver if the catch-fittings prove
difficult to release. Be careful not to make contact with the air outlet louver, as the louver edges can be
easily damaged.
(3) Slightly lift the front panel up to release the catch-fittings at four locations on the upper side of the unit.
Then pull the front panel forward to remove it.
(4) Remove the screw securing the electrical box cover and open it.
P5417052
Push the shaft
in the direction
of the arrow.
Screw
Screw Cap
When using a slotted
screwdriver, insert it
into the gap and push
the catch-fittings downwards.
Switch Cover
Electrical Box
Cover
Remove this screw
Remove this part
from the hole.
Front Panel
Lower Right Corner Cover
Holes for Catch-Fitting
Condensate Pan Fitting
Catch-Fittings for
Lower Side of Front Panel
Electrical Box Cover
Switch Cover
Press to
remove
Press
Unit
33