Table of Contents
Advertisement
User's Guide
Light
Status
Flashing alternately
A maintenance box is at the end of its
service life.
Flashing alternately
The maintenance box cannot be recognized.
Flashing alternately
The maintenance box is not installed.
Flashing alternately
There is not enough free space left in the
maintenance box to perform cleaning.
The printer has started in recovery mode
because the firmware update failed.
A printer error has occurred.
Related Information
"Removing Jammed Paper" on page 99
&
"Contacting Epson Support" on page 131
&
"Installing the Latest Applications" on page 91
&
Printer Basics
Solutions
The maintenance box needs to be replaced.
You cannot install a maintenance box that has already
been used in another printer. Install a new
maintenance box.
Install the maintenance box again.
Replace the maintenance box before cleaning. You
may still be able to print even if you cannot perform
cleaning.
Follow the steps below to try to update the firmware
again.
1. Connect the computer and the printer with a USB
cable. (During recovery mode, you cannot update the
firmware over a network connection.)
2. Visit your local Epson website for further
instructions.
Open the printer cover and remove any paper inside
the printer. Turn the power off and on again.
If the error continues to occur after turning the power
off and on again, contact Epson support.
16
Advertisement
Table of Contents
