Main Unit Rear Panel - Sony NSP-100 Operating Instructions Manual

Main Unit Rear Panel

1 S-OUT connector
1 S-OUT (S-video output) connector (mini-DIN 4-
pin)
This outputs the playback video as an S-video signal.
2 COMOPOSITE connector (BNC type)
This outputs the playback video as an analog composite
signal.
− −
3 G/Y, R/R Y, B/B
connector (BNC type)
This outputs the playback video as an analog component
signal. A DIP switch setting controls whether this is Y/
− −
R Y/B Y signals or RGB signals.
4 AUDIO OUT 1 and 2 connectors (pin jacks)
This outputs the playback audio as an analog signal. For
a stereo signal, connector 1 outputs the left channel, and
connector 2 the right channel.
(network) connector (RJ-45 modular jack)
5
This is a 100BASE-T connector for network (Ethernet)
connection.
Caution
When using a LAN cable: For safety, do not connect to
a connector for peripheral device wiring that might have
excessive voltage.
6 RS-232C/GPI (general-purpose interface)
connector (D-sub 9-pin, male)
6
Names and Functions of Parts
2 COMOPOSITE connector
3 G/Y, R/R
VIDEO OUT
G/Y
COMPOSITE
S-OUT
R/ B/
R-Y B-Y
Y (component video output)
− −
Y, B/B Y connector
4 AUDIO OUT 1 and 2 connectors
AUDIO OUT
VIDEO
1
1 NTSC COMPONENT
2 PAL RGB
RS-232C/GPI
2
6 RS-232C/GPI connector
5 Network connector
Connect to the D-sub 9-pin connector of a plasma
display or video monitor.
S400(6-pin, IEEE 1394 compliant)
7
Connect to the i.Link connector of a computer.
8 DIP switches
The settings of the four switches relate to the video
format, component video output signal, and remote
controller. The diagram of DIP switch settings above the
switches shows the significance of the two positions
("1" and "2") for each switch.
1 NTSC
2 PAL
VIDEO (video format/component video output
signal settings)
NTSC/PAL (leftmost switch): Select the video format.
COMPONENT/RGB (second switch from left):
Select output of a Y/R
from the G/Y, R/R
IRD REMOTE
ON 1
OFF 2
S400
1
2
8 DIP switches
S400 connector
7
DIP switch setting diagram
VIDEO IRD REMOTE
COMPONENT ON 1
RGB OFF 2
1
2
− −
Y/B Y signal or RGB signal
− −
Y, B/B Y connector.