Table of Contents
Advertisement
Names and Locations of Parts
Rear Panel
1 SDI IN connector
2 SDI OUT 1 and 2 connectors
1 SDI IN (SDI input) connector (BNC type)
Inputs SDI signals (D1 format) from the player.
2 SDI OUT (SDI output) 1 and 2 connectors (BNC
type)
Output SDI signals (D1 format) to the recorder.
Connectors 1 and 2 output the same signals.
3 REF IN (SD reference video signal input)
connectors (BNC type) and 75 Ω termination switch
As reference video signals, input video signals with
chroma burst or black and white video signals. Set the
75 Ω termination switch to OFF to bridge connect the
two connectors.
4 PLAYER REMOTE connector (D-sub 9-pin,
RS-422A)
Connect to the player's 9-pin remote connector.
5 RECORDER REMOTE connector (D-sub 9-pin,
RS-422A)
Connect to the recorder's 9-pin remote connector.
4
3 REF IN connectors and 75 Ω termination switch
4 PLAYER REMOTE connector
5 RECORDER REMOTE connector
6 REMOTE IN (RS-232C) connector
6 REMOTE IN (remote input) (RS-232C)
connector (D-sub 9-pin)
Use this connector to control this unit from a
computer.
7 RS-232C connector
Use this connector to connect this unit to a computer,
for example to perform self diagnostics.
8 TC OUT (timecode output) connector (XLR
3-pin, male)
When using a closed caption encoder as an external
device, connect it to this connector. This connector
does not need to be connected to the LTC input
connector of the VTR.
Note
Except during editing, this unit creates LTC timecode
from VITC included in the SDI input signal. There, if
VITC cannot be detected in the SDI input signal,
nothing is output from the TC OUT connector.
9 AC IN (AC power input) connector
Connect to AC power.
7 RS-232C connector
8 TC OUT connector
9 AC IN connector
Advertisement
Table of Contents
