Placement - Asko DC7774V User Manual

PLACEMENT

_______________________________________
The drying cabinet is intended only for use in-
doors in a dry place.
___________________________________________
___________________________________________
Do not place the drying cabinet in an area where
high-pressure washing is used for cleaning.
___________________________________________

The drying cabinet must be level on a fl at
surface, resting on all four feet.
Use the Allen key supplied and adjust the feet
through the holes in the baseplate of the drying
cabinet.
Press the four covering plugs fi rmly into the
holes after adjustment.

The cabinet must be attached to a wall to
prevent tipping over.
1 Open the door, pull out the upper hanging
section and drill 8 mm holes in the wall
through the two pre-drilled holes in the
rear of the drying cabinet (1).
2 Fit the plastic plugs in the wall (if neces-
sary). Fit the screw with the fl at washer as
illustrated.
Cover the holes with the cover plugs.
Screws for fi xing, washers and plastic plugs
are provided in the assembly kit.
__________________________________
CAUTION
The drying cabinet must not be used without
being attached to a wall owing to the risk of tip-
ping over forward.
___________________________________________
8 9
16
1
Drying cabinet with extended upper
hanger section
3
2 4
5
1. Pre-drilled holes
2. Wall plug
3. Wall behind drying cabinet
4. Fixing screws
5. Washer
6. Rear wall of drying cabinet
7. Cover plug
8. Spirit level
9. Cover plug
6
7