Troubleshooting - Bissell PowerForce 3522 User Manual

Clearing Clogs
The Hose on the back of the vacuum cleaner that carries
the dirt from the Powerfoot to the Dust Bag can sometimes
become clogged. If you notice a change in the sound of the
vacuum motor, check for clogs.
Unplug cleaner from electrical outlet.
1.
Pull the Bag Door outward to open and set aside. Remove the
2.
Dust Bag to check the Suction Inlet for a clog.
Grasp the Quick Reach Handle and lift up to separate from
3.
the Suction Intake Opening. Check for a clog in the Base, the
Wand or the Hose.
For models with the Twist 'n Snap Hose.
Release the hose from the vacuum by turning to
the right. Straighten the hose and unclog with a long,
narrow object.
If the clog persists, turn the vacuum cleaner OFF and unplug
4.
it. Remove the Brush Cover. Check the Air Passageway for
obstructions. Remove debris from this area. Reposition
Brush Cover and four screws. Tighten screws securely.
Make sure end of Brush Cover is snapped into place.

Troubleshooting

Vacuum cleaner won't run
Possible Causes
Power cord not firmly plugged in
1
Blown fuse/tripped breaker
2
Vacuum cleaner won't pick up dirt
Possible Causes
Incorrect Height Adjustment
1
Hose not attached to suction opening
2
Twist 'n Snap Hose not securely attached
3
Dust Bag is Full
4
Rotating Floor Brush bristles worn
5
Rotating Floor Brush jammed
6
Clog in vacuum
7
10
Suction
Inlet
Air Passageway
WARNING:
To reduce the risk of
injury from moving parts
and/ or electrical shock,
turn Power Switch OFF
and disconnect polarized
plug from electrical outlet
before performing
troubleshooting checks.
Remedies
Check electrical plug.
1
Check/Replace fuse or reset breaker.
2
Remedies
Adjust Powerfoot to correct height setting.
1
Grasp Hose Grip and firmly push onto
2
the base.
Make sure Twist 'n Snap Hose is snapped
3
into the locked position.
Replace with new Dust Bag.
4
Replace brush.
5
Remove brush and clean debris from
6
brush ends.
Follow instructions for clearing clogs.
7