Test Run - Grizzly G0677 Owner's Manual

Test Run

Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
The test run consists of verifying the following:
1) The motor powers up and runs correctly, 2)
the front and rear stop buttons work correctly,
3) the feed belt motor turns the correct direction
(machine is not wired out of phase), and 4) the
door safety limit switches work correctly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
Troubleshooting on Page 39.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
Before beginning the test run, review the basic
power controls in Basic Controls, beginning on
Page 24.
Before starting the planer/sander, make
sure you have performed the preceding
assembly and adjustment instructions, and
you have read through the rest of the man-
ual and are familiar with the various func-
tions and safety features on this machine.
Failure to follow this warning could result in
serious personal injury or even death!
To test run the machine:
1. Make sure you understand the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine,
and close all panels and access doors.
3.
Make sure the machine is connected to an air
compressor and the pressure gauge reads
75 PSI.
4. Make sure all wiring is correct.
-22-
5.
Put on your safety glasses.
6. Connect the machine to the power source.
7. Push the front and rear STOP buttons in, then
twist them clockwise so they pop out. When
the STOP buttons pop out, the switches are
reset and ready for operation (see Figure
23).
Figure 23. Resetting the switch.
8.
Verify that the power is not connected out of
phase by pressing the TABLE UP and TABLE
DOWN keys (see Figure 26, Page 25), using
the criteria below:
— If the table moves in the same direction
as the button description, the machine is
wired correctly.
— If the table moves in the opposite direction
to the arrow on the button, the power is
connected out of phase.
Stop the machine, DISCONNECT THE
POWER, then swap the L1 and L2 wires at
the terminal connection (see Figure 24).
R S T
L1 L2 L3
Figure 24. Example of switching wires at power
supply terminal connection.
220/440V
E
Operation
G R O U N D
G0677 24" Planer/Sander