Assembling; General Requirements; Simotion D410 Mounted On The Power Module - Siemens SIMOTION D410 Manual

Assembling

4.1

General requirements

Mounting options
SIMOTION D410 comes in two designs:
• Mounted on the power module: SIMOTION D410 is mounted on the power module.
• Operation away from the power module: SIMOTION D410 is mounted on a mounting
Open device
SIMOTION D410 is an open device! This means, you can only install the modules in
housings, cabinets or electrical equipment rooms. These may only be accessible via key or
tool. Housings, cabinets, or electrical equipment rooms may only be accessed by trained or
authorized personnel. An external fire-protection housing is required.
Danger
The system must be without power when you mount the housing.
4.2

SIMOTION D410 mounted on the power module

Overview
SIMOTION D410 can be snapped directly on the blocksize power module (e.g., PM340) via
the PM-IF interface.
Note
You can connect a blocksize or chassis power module to the DRIVE-CLiQ interface of
SIMOTION D410 using the CUA31 adapter module.
D410
Manual, 03/2007 Edition
plate.
4
43