Please Do Not Return This Product To The Store - Bissell 1697 User Manual

Troubleshooting Continued
Reduced Spray Or No Spray.
Possible Causes
The Pump Belt may be broken
1
PowerSteamer is not picking up solution.
Possible Causes
ReadyTools Dial may be at the
1
wrong setting for cleaning job.
Nozzle Window may not be properly attached
2
Tank-in-Tank Lid is not properly installed
3
Tank-in-Tank is not properly seated
4
Poor tool position.
5
(Handheld attachments only.)
Tank-in-Tank has picked up the maximum
6
dirty water
If you should happen to need assistance during assembly or operations, call 1-800-237-7691.

Please do not return this product to the store

14.
Thank you for selecting a BISSELL product.
Insert Screwdri v er Bl a de Here
Remedies
Turn the machine OFF and unplug
1
from the outlet. To check if a Pump
Belt has broken, you will need a
flat head screwdriver. Insert
the blade end into the lower slot of
the Belt Access door to release the
lower snap. If necessary, insert the
blade end into the upper slot to
release the upper snap. Examine
for belt breakage. You should be
able to see the Pump Belt looped
around the motor shaft. If it is
broken or missing, please refer to
Part Numbers and Descriptions on
page 15 before calling Consumer
Services. Complete installation
instructions will accompany the
replacement belt.
Remedies
Set ReadyTools Dial to either FLOOR
1
CLEANING or TOOLS/PRETREAT.
Make sure the two tabs on the back
2
of the Floor Nozzle Window are
inserted through the mating slots in
the main housing. Reinstall
if necessary.
Reinstall lid; refer to page 6.
3
Tank-in-Tank must be firmly seated to
4
function. Remove tank and check gasket
on tank bottom; Reseat tank.
Readjust angle; apply more
5
downward pressure.
Empty tank and refill; refer to
6
page 7.
Li f t Here