Chapter 7: Configuring The Wireless Controller - Using The Edm - Avaya WLAN 8100 Quick Start Manual

Chapter 7: Configuring the Wireless
Use this procedure to configure the Wireless Controller (WC) 8180 using the Enterprise Device
Manager (EDM).
Note:
This section describes the configuration of various WLAN features such as DiffServ, Client Band
Steering, Station Isolation, Auto-RF, Client Load Balancing and Remote Packet Capture using
the EDM. It also describes the enablement of support for third-party real-time location systems
such as AeroScout and Ekahau.
For more information on the WLAN supported features, see:
• The Feature Overview for Avaya WLAN 8100, NN47251-102.
• The ACLI Commands Reference for Avaya WLAN 8100, NN47251-107, for a complete list
of configuration commands for each of the features.
Before you begin
• Ensure that you have completed the preliminary controller configuration. See
preliminary controller configuration
This is mandatory before you can configure the controller using the EDM.
• Ensure that the controller has a management interface IP address that is reachable from the
PC hosting the EDM.
Procedure
1. Log on to Enterprise Device Manager (EDM).
To log on to the EDM, open a browser instance and enter:
http://<management Interface IP address of the controller>
Quick Start Overlay Deployment Configuration for Avaya WLAN 8100
76
Controller — using the EDM
on page 15.
Comments? infodev@avaya.com
Completing
June 2014