Synchro-Recording With Audio Equipment Of Your Choice (Music Synchro-Recording); Synchro-Recording With A Sony Cd Player - Sony MINIDISC MDS-JB920 Operating Instructions Manual

Recording on MDs
Synchro-Recording With Audio
Equipment of Your Choice
(Music Synchro-Recording)
By using the MUSIC SYNC button, you can
automatically start recording in sync with the signal
input from the program source.
The method of marking track numbers differs,
depending on the program source being recorded and
the setting of the Setup Menu 02 (see "Notes on
Recording" on page 12).
MUSIC SYNC
1
Do Steps 1 to 5 in "Recording on an MD" on
page 9.
2
Press MUSIC SYNC.
The deck changes to recording pause.
3
Start playing the program source you want to
record.
The deck starts recording automatically.
To stop Music Synchro-Recording
Press p.
Note
When Music Synchro-Recording, the Smart Space Function
and the Auto Cut Function turn on automatically regardless
of their setting (On or Off) and type of input (digital or
analog).
18 EN
REPEAT A˜B A.SPACE M.SCAN
>
/ 25 ? ! ( )
WRITE CLEAR P.HOLD
NAME CHAR NUM
· P p
REC-IT
= + r
T.REC MUSIC SYNC
MUSIC SYNC
0 )
CD-SYNC
STOP START STANDBY
CD PLAYER FADER
P = +
DIGITAL REC LEVEL
/ANALOG OUT LEVEL
Synchro-Recording With a Sony
CD Player Z
By connecting your deck to a Sony CD player or Hi-Fi
Component System, you can easily dub CDs onto MDs
using the CD synchro buttons on the remote. If your
deck is connected to a Sony CD player by a digital
input cable, track numbers are automatically marked
as appear on the original even when "T.Mark Off" is
selected in Setup Menu 02. If your deck is connected to
a Sony CD player by audio connecting cords through
the LINE (ANALOG) IN jacks, track numbers are
automatically marked when you set Setup Menu 02 to
"T.Mark LSyn" (see page 16).
As the same remote controls both the CD player and
the deck, you may have trouble operating both units if
they are far from each other. If you do, place the CD
player close to this deck.
REPEAT A˜B
/ > 25 ? ! (
WRITE
NAME CHAR NUM
·
P
= + r
START
T.REC
0 )
CD-SYNC
STOP START STANDBY
STOP
CD PLAYER
P = +
CD PLAYER P
1
Set the source selector on the amplifier to CD.
2
Do Steps 2 to 5 in "Recording on an MD" on page
9 to prepare the deck for recording.
3
Insert a CD into the CD player.
4
Select the playback mode (Shuffle Play, Program
Play, etc.) on the CD player.
5
Press STANDBY.
The CD player pauses for playing and the deck
pauses for recording.
A.SPACE M.SCAN
)
CLEAR P.HOLD
p
REC-IT
STANDBY
MUSIC SYNC
FADER
DIGITAL REC LEVEL
/ANALOG OUT LEVEL