Using The Beeps (Except For North American Model) - Sony MDS-S50 Operating Instructions Manual

Outputs
PHONES
ANALOG OUT
General
Power requirements
U.S.A. and Canadian models:
European models:
Australian models:
Hong Kong models:
Other models:
Power consumption
Dimensions (approx.)
Mass (approx.)
Supplied accessories
Audio connecting cords (2)
Optical cable (1)
Remote commander (remote) (1)
R6 (size-AA) batteries (2)
US and foreign patents licensed from Dolby
Laboratories.
Design and specifications are subject to change
without notice.
Jack type: stereo phone
Rated output: 10 mW
Load impedance: 32 ohms
Jack type: phono
Rated output: 2 Vrms (at
50 kilohms)
Load impedance: over 10
kilohms
120 V AC, 60Hz
230 V AC, 50/60Hz
240 V AC, 50/60Hz
220-240 V AC, 50/60Hz
110-120/220-240 V AC,
50/60Hz
Adjustable with voltage
selector
15 W
0.5 W (in the STANDBY
mode)
280 84.5 290 mm (w/
h/d) incl. projecting parts
and controls
2.4 kg
Using the beeps
(Except for North American model)
The deck can output various beeps that allow
you to identify deck operations by sound. The
beeps are output from the LINE (ANALOG)
OUT jacks.
Set BEEP (located at the rear panel of
the deck) to ON.
Beeps are output according to the deck status as
follows:
One short beep (high)
The deck has been turned on, started playing, started
1)
recording, etc.
Two short beep (high)
The deck has been turned off.
One short beep (low)
• The deck has stopped or the MD has been ejected.
• Menu operation has finished or canceled, normal
play mode has been resumed, recording level has
been set to 0 dB (default value) (i.e., the deck has
resumed the normal status).
The peak level meter is displayed.
Several beeps (low and high beeps
are output alternately)
The deck's self diagnosis function has been activated
and a code and message alternate in the display.
Consecutive beeps (high)
• An operation button was pressed with no MD
inserted.
• You cannot select an item or setting value by turning
AMS (or pressing ./> repeatedly).
• The remaining recordable time becomes less than 3
minutes during recording.
Consecutive beeps (low)
• The recording level or trigger level for Automatic
Track Marking has been set to maximum or
minimum.
• You cannot select an item or setting value by turning
AMS (or pressing ./> repeatedly).
One continuous beep (high)
z was pressed but the MD is full.
1)
continued
35