Sony MDS-S50 Operating Instructions Manual page 15

Operations you may want to do
during CD Synchro-recording
To Press
Stop recording CD-SYNCHRO STOP on
the remote
Pause recording CD-SYNCHRO STANDBY
on the remote
CD PLAYER ./> on
Locate the next track to
be recorded during the remote
recording pause
Resume recording after CD-SYNCHRO START on
pausing the remote
Check the remaining DISPLAY
recordable time on the
MD
Tips
• You can use the remote of the CD player during CD
Synchro-recording.
To change the
Press
deck to
H
Recording
x
Recording pause
X
Recording pause
• During CD Synchro-recording, track numbers are
marked in the following ways:
— When the CD player is connected to the
DIGITAL IN connector, track numbers are
automatically marked as they appear on the CD.
— When the CD player is connected to the
ANALOG IN jacks, track numbers are
automatically marked when "T.Mark Lsync" has
been selected (page 10).
— When you resume recording after recording
pause, a new track number is automatically
marked, regardless of the track marking
parameter setting ("T.Mark Lsync" or "T.Mark
Off").
• By reprograming the MD's remote, you can use the
procedure above to perform synchro-recording with
a Sony video CD player.
Press number button 2 on the remote while pressing
down ?/1 on the remote. You can now operate the
MD deck and the video CD player with the remote.
To control the CD player again, press number button
1 on the remote while pressing down ?/1 on the
remote.
And change the
CD player to
Play
Stop
Pause
Notes
• When performing CD Synchro-recording with a CD
player with a mode selector, be sure to set the
selector to CD1.
• When you record tracks from certain CD or multi-
disc players, the entire material may be recorded as a
single track.
15