Sony UWP-C1/C2 Operating Instructions Manual page 16

Parts Identification
4 Display section
A B
RF
AF
A RF (radio frequency) indications
The number of dots indicates the RF
input level.
B AF (audio frequency) indication
Appears whenever the output audio
signal is stronger than the reference
level.
C BATT (battery) indication
Shows the battery condition.
For details, see "Power Supply" on
page 20.
D GP (group)/CH (channel)
indication
Shows the reception channel group
and channel number. Each time you
press the SET button, the channel
indication changes as follows.
For details, see "Settings" on page 28.
Reception
channel
group and
number
Reception
frequency
Accumulated
battery use
time
16
C
BATT
CH
D
Press
the
SET
button.
5 + (+ selection) / – (– selection/
reset) buttons
Press these buttons to set the reception
channel and frequency. The "–"
button resets the accumulated battery
use time to "00:00". These buttons can
also be used to adjust the monitor
level.
6 Battery compartment
Accommodates two LR6 (size AA)
alkaline batteries.
For details on how to insert the
batteries, see "Power Supply" on
page 20.
7 SET button
Press to change display parameters.
For details, see "Settings" on page
28.
8 POWER switch
Turns the power of the tuner ON or
OFF.
9 OUTPUT (audio output)
connector (3.5-mm diameter stereo
mini jack)
Connect one end of the supplied XLR-
BMP conversion cable or the stereo
mini plug-BMP conversion cable here
and the other end to the microphone
input on a camcorder, mixer, or
amplifier. If the microphone input
connector on the device connected to
the tuner is a stereo mini jack, connect
the straight (BMP) plug (2-pole) to the
tuner and the L-shaped (stereo mini)
plug (3-pole) to the microphone input
connector on the device.