Disconnecting The Ic Recorder From Your Computer - Sony IC RECORDER ICD-SX750 User Manual

Computer
To USB port of
your computer
To
connector
USB connecting cable
IC recorder
While the batteries are charging,
"CONNECTING" and the battery indicator
are displayed in an animation.
When the battery indicator indicates "
charging is completed. (Charging time:
approx. 4 hours*)
When you use the IC recorder for the
first time, or after you have not used the
IC recorder for a certain period of time,
it is recommended that you charge
the batteries continuously until "
displayed.
If the battery indicator is not displayed,
charging has not been done properly.
Proceed from step 1 again.
(USB)
, "
" is
* This is an approximation for the time it takes
to charge from no remaining battery power
to full battery power at room temperature.
It varies depending on the remaining power
and the condition of the batteries. It also
takes more time if the temperature of the
batteries are low, or if the batteries are
charged while you are transferring data to
the IC recorder.
Disconnecting the IC
recorder from your
computer
Follow the procedures below; otherwise,
data may be damaged.
1
Make sure that the operation
indicator is not flashing.
2
Disconnect the USB connecting
cable connected to the IC recorder
from the USB port of the computer.
On the Windows screen, left-click
"Safely Remove Hardware" on the
taskbar, and click "Safely remove USB
Mass Storage Device. "
On the Macintosh screen, drag the "IC
RECORDER" on the desktop to "Trash"
and drop it there.
1
GB