Operating Procedures; Assembly - Taylor Freezemaster 300 Series Operating Instructions Manual

Section 6
Each unit stores mix in a hopper. The mix then flows
by gravity through an air tube down into the freezing
cylinder. They all have 2.8 quart (2.6 liter) capacity
freezing cylinders. All models have 20 quart (18.9 liter)
mix hoppers.
Duplicate the following procedures, where they apply,
for the second freezing cylinder.
We begin our instructions at the point where we enter
the store in the morning and find the parts
disassembled and laid out to air dry from the previous
night's cleaning.
These opening procedures will show you how to
assemble these parts into the freezer, sanitize them,
and prime the freezer with fresh mix in preparation to
serve your first portion.
If you are disassembling the machine for the first time
or need information to get to this starting point in our
instructions, turn to page 23, "Disassembly", and start
there.

Assembly

Note: When lubricating parts, use an approved food
grade lubricant (example: Taylor Lube).
MAKE SURE THE CONTROL SWITCH IS
IN THE "OFF" POSITION.
Step 1
Install the drive shaft. Lubricate the groove and shaft
portion that comes in contact with the bearing on the
beater drive shaft. Slide the seal over the shaft and
groove until it snaps into place.
Models 336, 338 & 339

Operating Procedures

DO NOT lubricate the hex end of the drive
shaft. Fill the inside portion of the seal with 1/4" more
lubricant and lubricate the flat side of the seal that fits
onto the rear shell bearing.
Insert the drive shaft into the freezing cylinder, hex end
first, and into the rear shell bearing until the seal fits
securely over the rear shell bearing. Engage the hex
end firmly into the drive coupling. Be sure the drive
shaft fits into the drive coupling without binding.
15
Figure 8
Figure 9
Operating Procedures