Siemens SIMATIC Ident Compact Operating Instructions page 4

NOTICE
Restriction to the approval of the wide-range power supply
Alterations to the SIMATIC RFID modules and devices as well as the use of SIMATIC RFID components with third-party
RFID devices are not permitted.
Failure to observe this requirement shall constitute a revocation of the radio equipment approvals, CE approval and
manufacturer's warranty. Furthermore, the compliance to any salient safety specifications of VDE/DIN, IEC, EN, UL and
CSA will not be guaranteed.
Safety notes for the US and Canada
The readers of the SIMATIC RF600 series may only be operated with the wide range power supply unit for SIMATIC RF
systems - as an optional component – or with power supply units that are UL-listed in combination with the safety standards
specified below:
● UL 60950-1 - Information Technology Equipment Safety - Part 1: General Requirements
● CSA C22.2 No. 60950 -1 - Safety of Information Technology Equipment
NOTICE
Warranty
The compliance of the SIMATIC RFID systems to the safety standards mentioned above and the conditions in the UL
approval will not be guaranteed if neither the wide-range power supply unit for SIMATIC RF systems nor power supplies
listed according to the safety standards named are used.
5 Mounting & connecting
The wide-range power supply unit for SIMATIC RF systems is sold with a country-specific power cable for EU, UK and US.
Note
Country-specific adaptation of the connector
When necessary, the primary cable can be adapted to country-specific conditions. The connector can be replaced by a
country-specific connector.
If you do this, make sure that the protective conductor is connected in the connector and that grounding is ensured. If the
protective conductor cannot be connected through the plug, you must connect the grounding connection to the mounting
④
hole provided by the metal shoe.
Follow the steps below to mount and connect the wide-range power supply unit:
1. Mount the wide-range power supply using the 4x screws.
Remember to make the grounding connection with the mounting hole
For detailed information on grounding and compliance with the EMC directives, refer to the "Grounding connection"
section below.
2. Connect the reader to the outputs
3. Connect the power cable to the primary input (PE)
4. Connect the power cable of the wide-range power supply unit to the voltage supply.
NOTICE
Plugging/pulling the power supply cable
Plugging or pulling the power cable of the wide-range power supply unit is only permitted when no voltage is applied
(powered-down)
4
② ③
and of the wide-range power supply unit.
①
of the wide-range power supply unit.
④
provided by the metal shoe.
Wide-range power supply unit for SIMATIC RF systems
J31069-D0169-U001-A5-7618, 07/2016